Your response can vary, depending on several factors: Total available space on your system. This command is used when replacinga physical disk in a drive magazine. The following example shows how to set Remote Copy interface 172. Any role in the system. This specifier can only be used withthe startgateway subcommand. It might compromise the securityof the storage system.
This information gives the system administrator a recordor log of the battery age and battery charge status. Virtual Volume Stats histvv Displays histogram data for virtual volumes. Issuing eitherthe moverelocpd or servicemag resume command can move the chunklet back to itsoriginal position. The value is failed if the media has encountered errors and is unavailable, or valid if it is available for use. The command also allows the addition of hosts to an existingset by use of the -add option.
Show all Boolean operators Not a command. Any role in the system. Consistent group snapshots are all created at the same point in time so that related structures ondifferent volumes in the group remain consistent. A range of nodes is separated with a hyphen 0—7. Remote Copy admitrcopylink Admits a network link for Remote Copy use. This optioncan only be used with the rcip ping subcommand.
I would like to explain my convictions on why our students are with the same sex and displaying bad behavior in schools. Misuse of this specifier can result in lost data on the system configured as the primary systemunder normal operating conditions. The command completes the process without prompting for confirmation. The Configure QoS dialog box displays current values see Figure 17 page 158. The free space includes the total free initialized and uninitialized spaces available for use. The command completed Thu Oct 4 15:29:05 2012. The createld command allows you to create a logical disk.
If enabled, automatic failover is triggered when a node goes down. Models can be specified in acomma-separated list. Logical Disk Stats histld Displays histogram data for logical disks. This state will automatically transition to Not-Started when the stability of the system has been successfully confirmed. If no count is specified, the command defaults to 2 seconds. Entries presentin the database but missing from the Name Server are removed.
CagePos—The position of the physical disk within the drive cage. Models can be displayed by issuing the showpd -i command. File Access Audit Settings setfsaudit Set File Access Audit settings. A system reporter licence will be required to enable the majority of the historic data reports to be viewed. Resets the mode of the port. Provides additional details of the move with General Information, ErrorInformation, or Degraded Information.
Multiple volumes or patterns can be repeated using a comma separated list. If this specifier is not used, theN:S:P specifier must be used. Each question is worth two 2 points unless shown otherwise. If this option is not used, the command requires confirmationbefore proceeding with its operation. Furthermore,if this command is issued with the spindown subcommand, data on the specified drive becomesinaccessible.
The valid range is between 1 to 255 and the default value is 8. Brenda and Ralph are debating on the subject of students of the same sex kissing in the hallways at school. Failure to update snapshot data does notaffect the write to the base volume. You must specify a column number. Note: There can be different causes for this failure, contact your authorized service provider for assistance. Maximum length is 127 characters. Thetarget is created with the creatercopytarget command.